ZXR10 Command Manual (QoS Volume)
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
76
Confidential and Proprietary Information of ZTE CORPORATION
This command is applied to ZXR10 T64E/T128.
This example describes how to configure the broadcast packet of
all the members based on vfi 1: set the <bps> to 8000 bit/s, set
the <burst-normal> to 20000, set the <burst-max>to 200000.
Sends the packet for the designated rate, discards the packet for
the exceed-action .
ZXR10(config)#rate-limit vpls vfi1 input all broadcast
8 20000 200000 conform-action transmit exceed-action drop
service-policy
Use this command to bind a policy mapping on interface input or
output direction. Cancel the settings with the no command.
Interface configuration
service-policy {input | output}<policy-map-name>
no service-policy {input | output}
input
output
<policy-map-name>
�
After the users bind a policy mapping in interface input or out-
put direction, the original interface PQ, CAR, WRED configura-
tions and so on will be invalid. If the users cancel interface
binding policy mapping, the original PQ, CAR, WRED configu-
rations can not be restored.
�
This command is applied to ZXR10 GER and ZXR10 T64/T128.
�
ZXR10 T64E/T128 does not have the parameter output.
This example describes how to configure interface fei_1/1 output
direction bound policy map policy_1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#service-policy output policy_1
transmit: Sends the packet
set-dscp-continue: Sets a DSCP value (0
~ 63) and evaluates the next rate-limit
command
set-dscp-transmit: Sets a DSCP value (0 ~
63) and sends the packet
set-prec-continue: Sets an IP precedence
value (0 ~ 7) and evaluates the next rate-limit
command
set-prec-transmit: Sets an IP precedence
value (0 ~ 7) and sends the packet
Input direction
Output direction
Policy map direction