Sony KDL-40SL140 Service Manual page 11

Viewing the Diagnostic List
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote Commander within a second of each other:
Channel 5
DISPLAY
The Self Check list displays.
Results for all of the following diagnostic items are displayed at the bottom of the screen. No error has occurred if the screen displays a "0".
Resets all settings
to the Factory Defaults
Stored Data
from ADC calibration
(from factory)
Diagnostic
List
Clearing the Diagnostic List
CAUTION: To remove the error indicator number you have to reset the settings back to the Factory Defaults. This action over-writes all customer
settings. Before performing this reset, contact the customer to determine what adjustments they have made.
1. Using the remote commander, select Factory Default button.
2. To reset the Diagnostic List, select Yes.
3. To start Auto Program, select Yes.
NOTE: Allow 30+ minutes for Auto Program to complete.
4. Using the customers information, reset their adjustments.
KDL-40SL140/46SL140
Volume + POWER .
This is the SAME as accessing Service Adjustments.
QR0.5-C510
Model Information: 40SL140 8000001
Factory Default
ADC Auto Calibration
Cr
424
Gain
ITU 709
Offset 1020
Gain
420
ITU 601
Offset
1020
Gain
456
VGA
16
Offset
2:MAIN POWER 0
3:DC ALERT1 0
4:DC ALERT2 0
5:DC ALERT3 0
Power On Time: 00001H
SMPTE
ColorBar100
Y Cb
1608 424
128 1020
1592 422
128 1020
1840 460
8 16
6:BL
7:TEMP
8:Audio
Software Version
Model Information & Serial Number
Power Time
0
1
Indicates an error was detected
0 Indicates no error was detected
KDL-40SL140/46SL140
11