GE 21 Owner's Manual page 36

Ofrecido por www.electromanuales.com
Before you call for service...
Troubleshooting Tips
Problem Possible Causes
Water has poor Water dispenser has not been
taste/odor used for a long time.
Water in first glass Normal when refrigerator
is warm is first installed.
Water dispenser has not been
used for a long time.
Water system has been drained.
Water dispenser Water supply line turned off
does not work or not connected.
Water filter clogged.
Air may be trapped in
the water system.
Water in reservoir is frozen
because the controls are set
too cold.
Water spurting from Newly-installed filter cartridge.
dispenser
No water or ice cube Supply line or shutoff valve
production is clogged.
Water filter clogged.
Filter cartridge not
properly installed.
Water is leaking from Glass not being held under
dispenser the dispenser long enough
after button is released.
Air may be present in the
water line system, causing
water to drip after being
dispensed.
36
What To Do
• Dispense water until all water in system is replenished.
• Wait 24 hours for the refrigerator to completely
cool down.
• Dispense water until all water is system is replenished.
• Allow several hours for replenished supply to chill.
• See Installing the water line.
• Replace filter cartridge or remove filter and install plug.
• Press the dispenser arm for at least 2 minutes.
• Set the refrigerator control to a warmer setting and wait
24 hours. If water does not dispense after 24 hours, call
for service.
• Run 1 1 ⁄ gallons from the dispenser to clear the system.
2
• Call a plumber.
• Replace filter cartridge or remove filter and install plug.
• Remove and reinstall filter cartridge, being certain that
it locks into place. The blade on the end of the cartridge
should be positioned vertically.
• Hold the glass underneath the dispenser for 2–3 seconds
after releasing the dispenser button. Water may continue
to dispense after the button is released.
• Dispense water for at least 2 minutes to remove air
from system.