Install Vent Covers; Complete Installation; Range Hood Use; Range Hood Controls - Jenn-Air 32inch (81.3 CM) WALL-MOUNTPERIMETRIC RANGE HOOD Installation Instructions And Use & Care Manual

Install Vent Covers

NOTE: This hood can be installed without the chimney covers
when venting directly out the back or when using the recirculation
kit with the top grille cap. See the "For non-vented (recirculating)
installation without vent cover only:" in the "Connect Vent"
section.
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two 4 x 8 mm screws.
NOTE: For vented installations the upper vent cover may be
reversed to hide slots.
C
D
A. Upper vent cover
B. Lower vent cover
C. 4 x 8 mm screws
D. Bracket
Secure the bottom of the duct with 2 - 4 x 8 mm screws.
12
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the "Range
Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light. See
the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The range hood controls are located at the bottom right hand
A
side of the canopy.
B
A. Louver holes (non-vented
[recirculating] installations only)
B. Duct covers
C. Canopy

Complete Installation

RANGE HOOD USE

G
D. Control panel
E. Grease filter
F. Grease filter release handle
G. Lamp housings

Range Hood Controls

A. Light on/off C. Fan speed minimum button
B. Fan off D. Fan speed medium button
E. Fan speed maximum button
A
B
C
D
E
F
A
B
C
D
E