Safety Switching Off Of Hot Plates; Safety Switching Off Of Baking Oven; Fault Diagnosis/What To Do If; Fault Codes - Electrolux Range Service Manual

6.5

Safety switching off of hot plates

The hot plates switch off automatically after:
- 6 hours for heating stage 1 - •2
- 5 hours for heating stage 3 – 4
- 4 hours for heating stage •4 - •5
- 1.5 hours for heating stage 6 - 9
unless manually switched off or modified before.
6.6

Safety switching off of baking oven

The baking oven switches off automatically after:
12.5 hours at 30 – 120 °C
8.5 hours at 120 – 200 °C
5.5 hours at 200 – 250 °C
1.5 hours at 250 – 300 °C
unless the temperature was modified or switched of by hand before.
7.

Fault diagnosis/What to do if ...?

7.1

Fault codes

Powerboard Oven
Display Fault
F0 No alarm
F1 Door cannot be locked.
F2 Door cannot be unlocked.
F3 Checksum error
F4 Temperature sensor without contact or
short-circuit.
F5 Sticking heater relay contacts at power
board.
F6 Power board has too high a temperature
F7 Wrong electrical connection
F8 No connection between power board and
interface
F9 Micro processor resets automatically
(Reset).
Powerboard Hot Plates
Display Fault
E1 Power board has too high a temperature
E2 Wrong electrical connection
E3 Checksum error
TSE-N 01.01 A. B.
Action
None
Check door lock.
Check door lock and unlocking
thermostat f11.
Make a mains reset by separating
the appliance from the main and
starting it again.
Check temperature sensor,
replace, if necessary.
Replace electronic system.
Check installation situation of air
duct and cooling fan for proper
functioning.
Connect appliance correctly and
start it again.
Replace electronic system.
Carry out a mains reset by
separating the appliance from the
main and starting it again.
Action
Check installation situation of air
duct and cooling fan for proper
functioning.
Connect appliance correctly and
start it again.
Make a mains reset by separating
the appliance from the main and
starting it again.
- 27 - 599 50 93 79 EN