Finding A Station - GMC Sierra Denali Classic 2007 Owner's Manual

®
To use AudioPilot , set the radio volume at a low to
moderate listening level. Begin listening while the
vehicle is stopped with the motor running; turn the
®
AudioPilot on by pressing the AUTO VOL button
until AVOL ON appears on the display. Then,
resume driving, gradually increasing the vehicle
speed. You will notice that your music sounds the
same regardless of background noises; such as
road noise, tire hum, or wind. With the AudioPilot
turned off, repeat this process again without
adjusting the volume or tone controls. you will
notice that background noise is now audible, and
will prevent you from hearing softer passages of the
music. To turn AudioPilot
until AVOL OFF appears on the display. For
additional information on AudioPilot
www.bose.com.

Finding a Station

BAND: Press this button to switch between FM1,
FM2, AM, or XM1 or XM2 (if equipped). The
display will show the selection.
TUNE: Turn this knob to select radio stations.
®
off, press AUTO VOL
®
, please visit
© ¨
SEEK : Press either the SEEK or the TYPE
arrows to go to the next or to the previous
station and stay there.
The radio will only seek stations with a strong
signal that are in the selected band.
© ¨
SCAN : Press and hold either the SCAN or
the TYPE arrows for two seconds until SCAN
®
appears on the display and you hear a beep. The
radio will go to a station, play for a few seconds,
then go on to the next station. Press either the
SCAN or the TYPE arrows again to stop scanning.
To scan preset stations, press and hold
either the SCAN or the TYPE arrows for more than
four seconds. PSCN will appear on the display and
you will hear a double beep. The radio will go to a
preset station, play for a few seconds, then go on to
the next preset station. Press either the SCAN or
the TYPE arrows again to stop scanning presets.
The radio will only scan stations with a strong signal
that are in the selected band.
211