2 - 8
Symbol LS3008 Product Reference Guide
Scanning with Intellistand
When the scanner is placed in the Intellistand, the scan pattern selected in hand-held triggered mode continues
(see
Scan Pattern on page
To operate the scanner in Intellistand:
Ensure the scanner is properly connected to the host (see the appropriate host chapter for information on host
1.
connections).
Insert the scanner in Intellistand by placing the front of the scanner into the stand's "cup."
2.
Cup
Scanner Holder
Inserting the Scanner in the Intellistand
Figure 2-7
Use the Intellistand's adjustment knobs to adjust the height and angle of the scanner.
3.
Present the bar code.
4.
NOTE When the bar code is in view, the scanner emits a full scan line. After 3 minutes, the scanner
automatically switches to a reduced scan line. After 1 hour, the scanner automatically switches to blink
mode.
Upon successful decode, the scanner beeps and the LED turns green. For more information about beeper and
5.
LED definitions, see
4-6).
Angle Adjustment Knob
Height Adjustment Knob
Table 2-1
and
Table
2-2.