Gigabyte GA-K8NS User Manual page 79

Press Y if you want to wipe out all the data from the RAID array, otherwise press N. You must choose
Yes if the drives were previously used as RAID drives. The Array List window appears, where you
can review the RAID arrays that you have set up.
You can select a disk array as boot device if you want to boot operating system from an array. Use the
arrow keys to select the array, then press B to specify the array as bootable.
[Ctrl-X] Exit [
Press Enter to view and verify details. The Array Detail screen appears.
The Array Detail screen shows various information about the array that you selected, such as Striping
Block used, RAID Mode, Striping Width, Disk Model Name, and disk capacity.
RAID Mode: Mirroring
Striping Width : 1
Adapt Channel
1 0
1 1
[R] Rebuild [D] Delete [C] Clear Disk [ENTER] Return
If you want to mark this disk as empty and wipe out all its contents, press C.
At the prompt, press Y to wipe out all the data, otherwise press N.
Press Enter again to go back to the previous screen and then press Ctrl + X to exit the RAID setup.
Now that the RAID setup has been configured from the RAID BIOS, the next step is to configure and load
drivers under Windows.
NVDIA RAID Utility Feb 13 2004
- Array List -
Boot Id Status Vendor
BBS 2 Health NVIDIA MIRROR 111.79G
] Select [B] Set Boot [N] New Array [ENTER] Detail
Array 2 : NVIDIA MIRROR 111.79G
- Array Detail -
Striping Block 32K
M/S Index
Master 0
Master 1
- 79 -
Array Model Name
Disk Model Name Capacity
ST3120026AS 111.79GB
ST3120026AS 111.79GB
Technical Reference