Messages Relating To Recording - Pioneer PDR-W739 Operating Instructions Manual

Compact disc recorder/multi-cd changer
Hide thumbs Also See for PDR-W739:
Table of Contents

Advertisement

9 Additional Information

Messages relating to recording

Message
Can't COPY
Can't REC
Can't SYNC
CHECK
INPUT (CD) ?
REPAIR
REC FULL
Pro DISC
Troubleshooting
It's often easy to mistake incorrect operation for trouble and malfunction of the unit. If you think there is something wrong with the
component, check the points below first. If the problem persists, contact you nearest Pioneer-authorized service center and have them
check over the unit. (See page 62)
60
En
Cause
The input signal is digital-copy
protected with SCMS.
The digital source was interrupted.
The source is not audio, or is an
incompatible format (e.g. a
CD–ROM).
The digital source is not recognized as
CD, MD, DVD, DAT, or DCC.
The source player was already playing
when the SYNCHRO button was
pressed.
The recorder was switched
off/unplugged after recording without
ejecting the disc. The recorder could
not write essential recording
information onto the disc.
No more recording is possible because
the available recording time of the disc
has been used up, or 99 tracks have
already been recorded on the disc.
The loaded disc is a CD–R or CD–RW
disc for professional use without the
Consumer Use designation.
Remedy
Record the source through the analog
inputs.
Check that the digital input cable is
connected properly and that the power of
the source player is on.
Check that the source is a regular music
source.
If recording from a source other than CD,
MD, DVD, DAT or DCC, try using the
manual digital recording mode.
Stop the source player. After a short time,
SYNC–1 or SYNC–ALL is displayed,
and the recorder goes into synchro–record-
pause mode.
While REPAIR is displayed, the recorder
automatically examines the recorded area
of the disc and updates the track numbers
and recording time data. This process takes
about 40 minutes for a fully recorded disc.
Finalization or further recording is possible
once the REPAIR message disappears.
Use another disc, or erase the
CD–RW disc.
Load a CD–R or CD–RW disc that is
designated as being for consumer use.
Page
p.46-49
p.11
p.48
p.46-49
p.8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents