Floppy Disk Controller; Serial Ata - Gigabyte GA-9ILDTH User Manual

Floppy disk controller

Enabled
Disabled
Floppy Check
Enabled
Disabled
Parallel ATA
Disabled
Both
Channel 0
Channel1

Serial ATA

Enabled
Disabled
Native Mode Operation
This option allows user to set the native mode for ATA function.
Note that certain OS is not supported under Native Mode.
Auto Auto detected. (Default value)
Serial ATA Set Native mode to Serial ATA.
Parallel ATA Set Native mode to Parallel ATA.
Both Set Native mode to Parallel ATA and Serial ATA.
Enable the floppy disk controller.
Disable the device. (Default value)
Enable the device to verify floppy typer when system boot.
Disable the this function. (Default value)
Disable the device.
Select both Channel 0 and Channel 1 as Parallel ATA.
(Default value)
Select both Channel 0 as Parallel ATA.
Select both Channel 1 as Parallel ATA.
Enable Serial ATA device. (Default value)
Disable the Serial ATA.
4 5
BIOS Setup