Bosch PowerPack 300 Original Instructions Manual

Bosch PowerPack 300 Original Instructions Manual

Hide thumbs Also See for PowerPack 300:

Advertisement

Robert Bosch GmbH
Bosch eBike Systems
72703 Reutlingen
Germany
www.bosch-ebike.com
0 276 001 YYY (2012.10) T / 142
Drive Unit Cruise | Intuvia |
PowerPack 300 | PowerPack 400 | Charger
0 275 007 006 | 0 275 007 007 | 1 270 020 903 | 0 275 007 500 | 0 275 007 501 |
0 275 007 502 | 0 275 007 503 | 0 275 007 504 | 0 275 007 505 | 0 275 007 905
en Original instructions

Advertisement

Table of Contents
loading

Summary of Contents for Bosch PowerPack 300

  • Page 1 Drive Unit Cruise | Intuvia | Germany PowerPack 300 | PowerPack 400 | Charger www.bosch-ebike.com 0 275 007 006 | 0 275 007 007 | 1 270 020 903 | 0 275 007 500 | 0 275 007 501 | 0 276 001 YYY (2012.10) T / 142...
  • Page 2 TURBO SPORT TOUR KM/H PMWH KM/H Reichweite 0 276 001 YYY | (12.10.12) Bosch eBike Systems...
  • Page 3 Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 4 0 276 001 YYY | (12.10.12) Bosch eBike Systems...
  • Page 5 Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 6 For safe operation see manual. Risk of electric shock. Dry location use only. Charge only batteries of WARNING the Bosch eBike Systems. Other batteries may burst causing personal damage. Do not replace the plug 0 275 007 905 assembly as risk of fire or electric shock may result.
  • Page 7 Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 8: Safety Notes

    16 Locking screw for drive HMI packs can lead to injuries and pose a fire hazard. When us- 17 Speed sensor ing other battery packs, Bosch shall not assume any liabil- 18 Spoke magnet of the speed sensor ity and warranty.
  • Page 9: Initial Operation

    “Switching the Push- Without the drive HMI, the eBike system cannot be assistance mode On/Off”, page English–4). The motor out- switched on. put depends on the settings of the drive HMI. Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 10 When the drive HMI is removed from holder 4, the last indicat- from the battery pack’s LEDs. ed assistance level is stored; the motor-output indicator a re- mains empty. 0 276 001 YYY | (12.10.12) Bosch eBike Systems...
  • Page 11 “RESET” button 6 until the indication is set to zero. This also despite corrective measures, please also refer to an resets the values of the other two functions. authorised bicycle dealer. Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 12: Notes On Riding With The Ebike System

    Connection problem of battery pack Have connections and contacts checked Incorrect polarity of battery pack Charge the battery pack with the original Bosch charger as described in the operating instructions. One or more buttons of the drive HMI Check if any buttons are blocked, e.g. from dirt or debris. Clean the are blocked.
  • Page 13: Maintenance And Service

    Protect the drive unit, drive HMI and bat- hold waste! tery pack against extreme temperatures (e.g. from intense sunlight without adequate ventilation). The components (es- pecially the battery pack) can become damaged through ex- treme temperatures. Bosch eBike Systems 0 276 001 YYY | (12.10.12)
  • Page 14 Please return battery packs that are no longer usable to an au- thorised bicycle dealer. Li-ion: Please observe the instructions in sec- tion “Transport”, page English–6. Subject to change without notice. 0 276 001 YYY | (12.10.12) Bosch eBike Systems...
  • Page 15: Lithium Ion Battery Pack Powerpack

    Read all safety warnings and packs can lead to injuries and pose a fire hazard. When us- all instructions. Failure to fol- ing other battery packs, Bosch shall not assume any liabil- low the warnings and instruc- ity and warranty.
  • Page 16: Technical Data

    HMI.  Use only the charger provided with your eBike or an identical original Bosch charger. Only this charger is When the capacity of the battery pack is below 5 %, all LEDs of charge-control indicator 21 on the battery pack go out;...
  • Page 17 60 % (3 to 4 LEDs lit on the charge-control indica- tor 21). packs can lead to injuries and pose a fire hazard. When us- ing other battery packs, Bosch shall not assume any liabil- Check the charge condition after 6 months. When only one ity and warranty.
  • Page 18 Please also observe possibly more detailed national regula- tions. In case of questions concerning transport of the battery packs, please refer to an authorised bicycle dealer. Bicycle dealers can also provide suitable transport packaging. 0 276 001 YYY | (12.10.12) Bosch eBike Systems...
  • Page 19 – Dry location use only. The term “battery pack” used in these operating instructions – Charge only batteries of the Bosch eBike Systems. Oth- refers both to standard battery packs (battery packs with er batteries may burst causing personal damage.
  • Page 20: Troubleshooting Measures

    Battery Charger Charger indicator 21 light up continuously. The charge procedure is Charging time automatically ended. – PowerPack 300 Disconnect the charger from the mains supply and the battery – PowerPack 400 pack from the charger. Number of battery cells 10 –80...
  • Page 21 Equipment and its implementation into national right, battery chargers that are no longer usable must be collected sepa- rately and disposed of in an environmental correct manner. Subject to change without notice. Bosch eBike Systems 0 276 001 YYY | (12.10.12)

This manual is also suitable for:

Powerpack 400Drive unit cruiseIntuviaCharger

Table of Contents