Specifications; Maintenance - Sharp XL-DAB1H Operation Manual

Troubleshooting chart (continued)
■
Factory reset, clearing all memory
1
Press the ON/STAND-BY button to enter the power
stand-by mode.
2
Press the STOP button followed by ON/STAND-BY
button on main unit and hold it simultaneously for more
than 5 seconds until "CLR ALL" appears.
Caution:
This operation will erase all data stored in memory
including clock, timer settings, tuner preset, DAB+ preset
and CD program.
■
Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on
the disc surface. Follow the guidelines below for maximum
enjoyment from your CD collection and player.
●
Do not write on either side of the disc, particularly the
non-label side from which signals are read. Do not
mark this surface.
●
Keep your discs away from direct sunlight, heat, and
excessive moisture.
●
Always hold the CDs by the edges. Fingerprints, dirt,
or water on the CDs can cause noise or mistracking.
If a CD is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the centre,
along the radius.
NO

Maintenance

■
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted
soap solution, then with a dry cloth.
Caution:
●
Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet.
●
Do not apply oil to the inside of the unit. It may cause
malfunctions.
Specifi cations
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specifi cation
changes for product improvement without prior notice. The
performance specifi cation fi gures indicated are nominal
values of production units. There may be some deviations
from these values in individual units.
■
Power source
Power consumption
Dimensions
Weight
(*) This power consumption value is obtained when the
■
Output power
Output
terminals
■
Type
Signal readout
YES
D/A converter
Correct
Frequency
response
Dynamic range
■
Type
Maximum input
power
Rated input power
Impedance
Dimensions
Weight
■
Frequency range
E-14
General
AC 220 - 240 V ~ 50/60 Hz
Power on: 21 W
Power stand-by: 0.4 W (*)
Width: 190 mm (7 - 1/2")
Height: 115.7 mm (4 - 9/16")
Depth: 230.4 mm (9 - 1/16")
2.4 kg (5.31 lbs.)
main unit is in stand-by mode.
Amplifi er
MPO: 14 W (7 W + 7 W) (10% T.H.D.)
RMS: 10 W (5 W + 5 W) (10% T.H.D.)
RMS: 8 W (4 W + 4 W) (1% T.H.D.)
Speakers: 4 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
CD player
Single disc multi-play compact
disc player
Non-contact, 3-beam
semiconductor laser pickup
Multi bit D/A converter
20 - 20,000 Hz
90 dB (1 kHz)
Speaker
1-way type speaker system
8 cm (3") Full range
10 W
5 W
4 ohms
Width: 111 mm (4 - 3/8")
Height: 194 mm (7 - 5/8")
Depth: 180 mm (7 - 1/16")
1.3 kg (2.8 lbs.)/each
Tuner
FM: 87.5 - 108 MHz