VuQube VQ1000 Operating Instructions Manual page 13

4. Press and hold the MODE button until the segments on the display
all start turning black.
When all of the segments turn black, "AUTO" will appear,
and the display will return to its normal condition,
displaying the current elevation of the antenna and
the direction it is pointing.
RUN CHECK SWITCH
5. Run the check switch procedure again following steps 3-6 in STEP 1 on page 7.
The receiver will perform a check switch test. (This process will take several minutes.)
When test is complete, a screen similar to one on page 12 should appear.
Receivers are always changing, and therefore screen graphics may vary.
(Older Dish receivers, for example, may not show "OK" for the 72 satellite.)
If indicated results as shown on page 12 are not obtained, run test again. Contact King
Controls if the check switch fails to load after 4 attempts.
6. Save the settings, exit to the main menu screen and wait for programming to download.
7. DISH HD Western Arc with Locals and Dish HD Alternate with Locals only: Verify your
saved settings show your desired satellite trio 110, 119, 129, or 61.5, 110, 119.
8. Automatic satellite switching is now active. The antenna will switch to the appropriate
satellite based on the channel you select using the receiver's remote control. Enjoy!
Note: The new check switch setting (SW21 or SW64) will remain active in the receiver until you re-run the check
switch test when connected to your home dish. When moving the receiver between the VuQube and your home
dish, you must always reconfigure the receiver by running a new check switch test.
If you move the VuQube you will have to re-acquire the satellites using Normal Operating Mode. Follow steps
1-4 on pages 10-11 to put the unit in Normal Operating Mode. Make sure the "x" lights up when Mode 01 is
displayed.
Re-acquire the satellites (page 9) and re-enter the appropriate switching mode (page 10).
You will not have to rerun the check switch when re-entering automatic mode after re-acquiring the satellites
(see page 10 for exceptions).
You must also follow this procedure if you wish to automatically switch between a new set of satellites.
Page 11