Victor V-9 Operating Instructions Manual

OPERATING INSTRUCTIONS

IMPORTANT: The HEPA filter and Dust Bag must be in position prior to machine operation.
1) Attach Hose Assembly to Bottom Tub
Push appropriate end of Hose assembly firmly into the intake radius and rotate clockwise to lock.
Push other end of hose onto the intake hole of the Steel Down Tube(s) if required or applicable task tool. ie.
a) 32mm Combined Floor Tool. (see note below)
b) 32mm Crevice Nozzle.
c) 32mm Dusting Brush.
d) 32mm Carpet/Upholstery Tool
NOTE: The 32mm Combined Floor Tool can be set to vacuum either hard floor or carpeted areas by depressing
either of the 2 switches (as required) located on the top face of the actual floor tool.
2) Operate the machine.
Uncoil cable from its housing around the outside of the Power Head.
Plug the machine into an appropriate power supply outlet.
Move On/Off switch to the on position.
Pull the machine behind you as you select the areas to be cleaned. The machine will move easily on its castors.
Vary the suction level by opening or closing the air intake switch located on the end of the Hose Assembly.
3
2
4
1
3
8
6
10
7
5
SPECIFIC MAINTENANCE
Always remove plug from socket outlet before carrying out any specific maintenance
• CABLE
After use, always rewind cable back around Power Head section of tub from the cable inlet
(Cable restraint) outwards towards the 10Amp plug. This will reduce the risk of cable twist and prolong cable
life. (See safety section)
HEPA FILTER
For continued maximum efficiency of the filtration level, regularly remove the HEPA filter assembly from the
Power Head and gently shake dust particles clear. It is recommended that the HEPA filter is replaced
approximately every twelve months.(See Replacement section)
PAPER FILTER DUST BAG
When the dust bag is full,(motor sound may become higher pitched) remove the dust bag from the Bottom
Tub by unclipping the Power Head from the Tub and removing the filter assembly to expose the bag. Remove
the dust bag from the air intake radius and dispose of contents in a safe approved location. Place a new
dust bag into the radius and replace the above. (See Replacement section).
Please visit our web site: www.victorfloorcare.com
1. Power Head
2. Steel Down tube(s)
3. Air Intake Switch
4. Hose Assembly
5. Intake Radius
6. Bottom Tub
7. Floor Tool
8. Clip
9. Quick Release Cable Inlet
10. On-Off Switch
9
to find a full parts diagram for this machine