Chevrolet Cruze Owner's Manual page 70

66 Instruments and controls
Display of remaining engine oil life
The remaining engine oil life duration
is displayed in the Driver Information
Center by the control indicator
followed by a percent value which
shows the remaining engine oil life. For
this purpose the ignition has to be
switched on without engine running.
Driver Information Center 72.
Service Information 163.
How to reset the engine oil life system
Reset the system whenever the engine
oil is changed so that the system can
calculate the next engine oil change. To
reset the engine oil life system, do one
of the following:
Using a scan tool:
n
Your CHEVROLET retailer
reset the system using this tool after
changing the engine oil.
Using accelerator pedal:
n
¡»Remove key from ignition switch
or with Start/Stop system switch
off ignition for more than one
,
minute.
¡»Insert key in ignition switch and
turn key to position 2 or with
Start/Stop system switch on
ignition (ignition on but with
engine off).
¡»Fully press the accelerator pedal
and hold for two seconds.
¡» Release the accelerator pedal for
two seconds.
Repeat pressing and releasing of
the accelerator pedal as described
above two times within one
minute.
Using the SET/CLR button on
n
vehicles with Midlevel-Display:
Press the MENU button on the turn
signal lever to select the Vehicle
will
Information Menu. Turn the
adjuster wheel until the menu with
the remaining engine oil life
duration is displayed. Press SET/
CLR button for a few seconds with
ignition on. If Code 82 still appears
in the Driver Information Center
after the vehicle has been started,
the engine oil life system has not
been reset. Repeat the procedure.
n Using the reset knob on vehicles
with Baselevel-Display*: