Changing The Plug; Servicing The Appliance; Troubleshooting - Salton Elite SIM30E Instructions And Warranty Information

Table of Contents

Advertisement

CHANGING THE PLUG

Should the need arise to change the fitted plug, follow the instructions below.
This unit is designed to operate on 230V-240V current only. Connecting to other
power sources may damage the appliance. Connect a three-pin plug as follows:
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow = Earth

SERVICING THE APPLIANCE

Please note that this unit has NO user serviceable parts. Any attempt to service it will
nullify the warrantee.
TROUBLE SHOOTING
If the unit is not operating correctly, please check the following:
PROBLEM
THE COMPRESSOR
MAKES A THUNDERING
NOISE
'FILL WATER"
INDICATOR IS ON BUT
THERE IS ENOUGH
WATER IN THE TANK
"ICE FULL" INDICATOR
IS ON BUT THERE IS
LITTLE ICE IN THE
STORAGE BOX
"fill water" indicator
and "ice full"
indicator are on in the
same time.
COMPRESSOR CAN
NOT MAKE ICE
IT CAN MAKE ICE BUT
CAN NOT PULL THE ICE
OFF THE SHOVEL
AUTOMATICALLY
THE MACHINE STOPS
SUDDENLY DURING
THE ICE-MAKING
PROCESS
Blue = Neutral
POSSIBLE CAUSE
THE VOLTAGE IS LOWER
THAN REQUIRED
THE WATER PUMP IS
DAMAGED, CAN NOT PUMP
WATER
THE WATER DETECTOR IS
NOT 'SEEING' THE WATER
THE TEMPERATURE OF THE
STORAGE BOX IS TOO LOW
THE ICE SHOVEL CANNOT
WORK
ICE STORAGE BOX IS FULL,
THE SHOVEL IS BLOCKED BY
THE ICE
THE ICE IS TOO BIG AND IS
BLOCKING THE SHOVEL
THE SHOVEL HAS SHIFTED
AND IS BLOCKED
POSITION SWITCH IS
UNWORKABLE
REFRIGERANT HAS LEAKED
ELECTROMAGNETIC VALVE
HAS LEAKED
ELECTROMAGNETIC VALVE
IS DAMAGED
POWER WIRE IS DAMAGED
THE SURGE-PROTECTOR
STOPPED THE MACHINE AS
IT IS TOO HOT
5
Brown = Live
POSSIBLE SOLUTION
TURN OFF THE MACHINE, RESTART
UNTIL THE VOLTAGE BECOMES NORMAL
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
ADJUST THE WATER DETECTOR AND
AIM IT AT THE OUTLET OF THE WATER
PIPE
OPEN THE FRONT COVER, CLOSE UNTIL
THE INDICATOR LIGHT IS OFF
TAKE OUT THE ICE AND RESTART THE
MACHINE
TAKE OUT THE ICE AND RESTART THE
MACHINE
TURN OFF THE MACHINE AND TAKE OUT
THE ICE THEN RESTART THE MACHINE
TURN OFF THE MACHINE AND RE-PLACE
THE SHOVEL
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
CONTACT YOUR LOCAL SERVICE
DEPARTMENT
TURN OFF THE MACHINE AND RESTART
AFTER ONE HOUR

Advertisement

Table of Contents
loading

Table of Contents