Connecting Example: Av Equipment - Panasonic PT-EX16KE Operating Instructions Manual

Connecting example: AV equipment

Video, S-video, DVD
player, and HDMI video
output devices
To S-video output
To component
video output
To composite
video output
To HDMI output
To AV HDCP
DVI video output
Attention
z Always use one of the following when connecting a VCR.
–■A VCR with built-in time base corrector (TBC)
–■A time base corrector (TBC) between the projector and the VCR
z If burst signals are connected to nonstandard signals, the image may be distorted. In such a case, connect a
time base corrector (TBC) between the projector and the device.
Note
z Use an HDMI High Speed cable that adheres to the HDMI standard. Use of a cable that does not adhere to the
HDMI standard, may result in abnormal operation such as cut-out of the image, failure to project, etc.
z The <HDMI IN> terminal can be connected with an external device with a DVI terminal using an HDMI/DVI
conversion cable. With some devices, however, the image may not appear. (
z The <DIGITAL (DVI-D) IN> terminal can be connected to HDMI and DVI-D compatible devices, but normal
operation may not be possible with certain devices and the image may not appear.
z The <DIGITAL (DVI-D) IN> terminal (in the digital signal input mode) is compatible only with single link signals.
S-video cable
To <S-VIDEO IN> terminal
BNC cable
To <Y,Pb/Cb,Pr/Cr IN> terminal
BNC cable
To <VIDEO IN> terminal
HDMI cable
To <HDMI IN> terminal
DVI-D cable
To <DIGITAL (DVI-D) IN>
terminal
Connections
page 65)

ENGLISH - 27