Indoor Unit - Toshiba RAS-M10YKV-E Service Manual

9-2. Indoor Unit

Clip anchor
Front cabinet
(local part)
Front panel
7 Deodorizing
filter
6 Purifying
filter
Before install the wireless remote control
Wireless remote control
• With the remote control cover open,
load the batteries supplied correctly,
observing their polarity.
9-2-1. Accessory and Installation Parts
Part No.
1
Installation plate x 1
2
Wireless remote controller x 1
3
Battery x 2
4
Remote controller holder x 1
5
Pan head wood screw Ø3.1x 16 x 2
Hanger
Hanger
Hanger
9
5 Pan head
wood screw
4 Remote
2
Wireless
controller
remote
holder
controller
2
Batteries
3
Cover
Name of parts (Q'ty)
1 Installation
plate
Insert the something by fist-size between the
indoor unit and wall, and lift indoor unit to make
work easier.
Do not allow the drain hose to get slack.
Mounting
screw
Make sure to run the drain hose sloped downward.
The auxiliary piping can be connected the
Shield pipe
left, rear left, rear, right or bottom.
(local part)
Right
Rear
Insulation of refrigerant pipes insulates the pipes
separately, not together.
6 mm thick heat resisting polyethylene foam
(Inside of the ceiling).
Use 10 mm thick heat resisting polyethylene
foam.
Part No.
6
Purifying filter x 1
7
Deodorizing filter x 1
8
B Label x 2
9
Mounting screw Ø4 x 25 x 6
10
Indoor unit Installation manual x 1
– 65 –
For the rear left and left piping
Wall
Cut the piping hole
sloped slightly
Bottom
Rear left
Name of parts (Q'ty)
B
Left