Assembly & Set-Up - Cub Cadet 182 Operator's Manual

Assembly & Set-Up
Contents of Carton
• One Lawn Mower
• One Cord Guide Bar
Assembly
Handle
1. Remove any packing material which may be between
upper and lower handles.
a. Loosen each hand knob found on the inside of the
upper handle.
b. Gently lift and pivot the upper handle into the
operating position as shown in Fig. 3-1.
c. Remove star knobs from handle mounting brackets
and secure the lower handle onto the handle
brackets by placing the lower hole of the lower
handle onto the pins of the handle brackets.
d. Secure the upper handle and lower handle by
tightening the hand knobs. Each carriage bolt must
be seated properly into the square hole found in the
plastic connector.
8
• One Grass Catcher
• One Lawn Mower Operator's Manual
Figure 3-1
• One Side Discharge Chute
2. Tighten star knobs securing lower handle to handle
brackets. See Fig. 3-2. Make certain the lower handle is
seated securely into the handle mounting brackets.
Figure 3-2
Cord Guide Bar
Attach the cord guide bar with extension cord retainer to the
upper handle as shown in Fig. 3-3.
Figure 3-3
3