Sharp LC-20SH4U Service Manual page 26

LC-20SH4U
5. On Setting Items
* "EZ-SETUP" discussed below indicates "EZ-SETUP after the first power-on".
(1) POWER ON FIXED
Selection Selection between
Default – (Variable)
"
Explanation In Fixed
received. The power can be turned off by stopping the power supply from AC.
Limit in Setting Refer to the
Exception None
Remarks » Selection of
In
»
switch is off.
» Display ON/OFF in hotel menu is controlled by adjustment process
(2) MAXIMUM VOLUME
Selection Adjustment from 1 to 60 (no loop)
Default 60
Explanation Sound volume can not be adjusted higher than the preset value.
Limit in Setting » When the sound volume is set lower than 59, only figures are displayed and the sound volume bar is not
displayed.
The maximum sound volume for ON-timer (Wake up timer) is limited also to the preset value.
»
Exception » In the item
setting.
Remarks » Setting is valid only for the speakers of the unit. (As for the headphone, the sound volume can be set up
to 60 irrespective of the limit.)
» In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of
pre-adjusted value.
» When the sound volume is set higher than the MAX setting by the adjusting process or headphone, the
sound volume control operation is prohibited for turn-up and the sound volume should be turned down to
MAX in this state.
(3) VOLUME FIXED
Selection Selection between
Default Variable
Explanation Sound volume is fixed and made invariable.
Limit in Setting The sound volume for the ON-timer (Wake up timer) is fixed also without display of menu. Besides, the
»
setting is made impossible. (Basically, the menu is not displayed.)
» The following keys become invalid:
Sound volume Up/Down (VOL +/-) [for both remote control and the unit]
»
» Mute (MUTE)
Exception » In the item
setting.
Remarks In
»
abolished (and follows the last memory).
» The sound volume for the ON-time is not set at 1 either and the sound volume set value of the ON-timer
before executing the hotel mode is held.
» Setting is valid only for the speakers of the unit. (As for the headphone, the sound volume can be set up
to 60 irrespective of the limit.)
» In line output (sound volume variable), the sound volume can be adjusted from -60 to 0 irrespective of
pre-adjusted value.
» As for sound volume fixing and sound volume MAX level, the sound volume fixing has priority.
» Once the sound volume has been changed by adjustment process or headphone, it should be set back to
the sound volume preset by sound volume fixing level when the adjustment process ends or when the
headphone is removed.
" "
Variable and
"
setting, the power-off by the power key of the unit is invalidated and the image is kept being
" "
Power-On Fixed sheet.
" "
FIXED depends on use of STB etc.
" "
Variable setting, the power operation is in wait for 1 sec. and then turned off when the main power
" "
VOLUME of adjustment process, the sound volume can be set freely irrespective of this
"Variable" and "Fixed" (loop provided)
" "
VOLUME of adjustment process, the sound volume can be set freely irrespective of this
" "
Variable setting, the sound volume had been conventionally set at 1 but this operation has been
" "
Fixed (loop provided)
26
" "
HOTEL POWERFIX .