Recommended Cutting Equipment For Canada - Jonsered CS2156 Operator's Manual

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96
Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar
Length, inches Pitch, inch
13 0,325"
15 0,325"
16 0,325"
18 0,325"
15 3/8"
16 3/8"
18 3/8"
20 3/8"
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm -
0,058"/1,5mm S25/21BP
0,063"/1,6 mm -
D
_
D
PITCH =
2
TECHNICAL DATA
Chain
Max nose radius
10T
10T
Jonsered S25 or Oregon 21BP
10T
10T
11T
11T
Jonsered S42 or Oregon 73LP
11T
11T
-
S42/73LP
-
L
– 37
Canadian