Back Of Display Unit; Display Unit Setup; Power Adapter; Install Or Replace Batteries - AcuRite 06007RM Instruction Manual

Back of Display Unit

3
4
5
6

Display Unit Setup

Set the A-B-C Switch
1
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same letter
choices for both the sensor and
the display unit in order for the
units to synchronize.

Install or Replace Batteries

2
Insert 6 x AA alkaline batteries
into the battery compartment,
as shown. Follow the polarity
(+/-) diagram in the battery
compartment.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2 1
7
BACK OF DISPLAY UNIT
1. Integrated Hang Hole
For easy wall mounting
2. Plugin for Power Adapter
3. A-B-C Switch
ID code that must match 5-in-
1 sensor's A-B-C switch to en-
sure units synchronize
4. Clear Today
Clears data recorded since
12:00am
5. Clear All
Clears all recorded data
without having to reset time
and date
8
6. Reset
Full reset to factory defaults
7. Battery Compartment

8. Power Adapter

9. Battery Compartment Cover
(not shown)
A B C
1
A-B-C Switch
set to match sensor
4
2
Install Backup
Batteries
(optional)
6 AA Batteries