Setting The Baud Rate, Parity And Protocol (Sw5 And Sw6); Table 3-5 Dip Switch Sw5 Protocol Settings - Honeywell ACUIX Installation And Configuration Manual

Setting the Baud Rate, Parity and Protocol (SW5 and SW6)

Protocol Name
IntelliBus™
MAXPRO-mode
VCL - RS485
VCL Video Telemetry
(Control over Coax)
Diamond
Pelco P
Pelco D
Pelco P_AD
Pelco D_AD
Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Caution Leave SW5-8 ON. Setting the DIP switch SW5-8 to OFF enables a user to
change the address, protocol, baud rate and parity from the OSD menu
(which is not recommended with most installations).
Note If there are invalid protocol or baud settings on SW5 or SW6 the system
defaults to MAXPRO-mode at 9600 baud rate.
1. Set the protocol on switch SW5 in the required positions using
MAXPRO-mode is the default.
2. Set the baud rate and parity on switch SW6 in the required positions using
Table 3-6. 9600 baud and even parity are the defaults.
Table 3-5 DIP Switch SW5 Protocol Settings
1
OFF OFF
OFF
ON
OFF OFF
ON OFF
ON OFF
OFF
ON OFF
OFF
Switch Position
2 3 4
OFF OFF OFF
ON OFF OFF OFF
ON OFF OFF OFF
ON OFF OFF
OFF OFF OFF
ON OFF OFF
ON ON OFF OFF
ON OFF
ON ON OFF
Table 3-5.
5 6 7
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ON OFF OFF
ON OFF OFF
8
ON
ON
ON
ON
ON
ON
ON
ON
ON
41