Hitachi 36SDX01SR Service Manual

SERVICE MANUAL

NTSC
Models 36SDX01SR/36SDX01S and 36SDX88B are in the same Solid State Color Television fam-
ily. The main difference between the 36SDX01SR/36SDX01S and 36SDX88B is the control panel
and the CRT. Please refer to model 36SDX88B schematics, assembly, wiring, test and trou-
bleshooting information when servicing models 36SDX01SR/36SDX01S. Refer to Service Manual
PA No. 0110 issued in December 1998.
Please refer to Service Manual PA No. 0110 when adjusting 36SDX01SR/36SDX01S. The only difference is the Chopper Voltage as
stated below.
SYMBOL
DESCRIPTION
NO.
# CHOPPER VOLTAGE ADJUSTMENT
(PA No. 0110 SECTION 2.3.1 PAGE 47)
RT01 FOCUS ADJUSTMENT
(PA No. 0110 SECTION 3.3 PAGE 81)
36SDX01S/MM1T ONLY
5. Vertical Line Adjustment
Adjust Focus on Cross-Hatch Circle Pattern focusing
the point as shown in the right figure.
6. Adjust RT01 focusing only at vertical line so that it
becomes the most thick; the adjustment point which
can be seen the clearest without any saturation.
Concentration point:
Inner point of the circle as shown in the fight figure.
Note:
Adjust Horizontal Center Focus again after adjusting
Vertical Focus.
SPECIFICATIONS AND PARTS ARE SUBJECT TO CHANGE FOR IMPROVEMENT
S O L I D S TAT E C O L O R T E L E V I S I O N
MAY 2000
MM1R/MM1T
ADJUSTMENT
36SDX88B/MM1
VGA MODE=112±0.5V
DTV MODE=124±0.5V
SVGA MODE=140±0.5V
SAME AS STATED
IN PA No. 0110.
PA
36SDX01SR/MM1R
36SDX01S/MM1T
R/C: CLU-433FC
36SDX01SR/MM1R
VGA MODE=112±0.5V
DTV MODE=124±0.5V
SVGA MODE=140±0.5V
SAME AS STATED
IN PA No. 0110.
The end of
Cross-Hatch
The second vertical line from
the left end.
HHEA-MANUFACTURING DIVISION
No. 0140
36SDX01S/MM1T
VGA MODE=105±0.5V
DTV MODE=120±0.5V
SVGA MODE=135±0.5V
SEE BELOW
CPT PWB
RT01
REAR VIEW