Configure System Via Ftp - Vivotek IP2111 User Manual

Configure System via FTP

Administrators can use FTP to configure Network Camera much quicker than Web page
especially for multiple targets. To configure system via FTP, first download the parameter
file, CONFIG.INI, to customize each field according to the environment and then upload
back to validate the new settings. To log into the FTP daemon, enter "root" as the user
name and the same password used when connecting to the Web server. The serial
number of Network Camera is the password for the initial access.
The file is composed of eight categories: [SYSTEM], [LAYOUT], [NETWORK], [VIDEO],
[SERIAL1], [SERIAL2], [ALERT], and [DEMO]. The category name in brackets should be
in upper case. The item name in angle braces should be in lower case. Some items
related to disable/enable should use the keywords "YES"/"NO". The number zero entry in
<user name> and <user password> is for administrators, i.e. "root". Basically Network
Camera will restart automatically as soon as the file is accepted. If administrators want
to cancel the reboot procedure, set the first item, <reset system> to NO. It will take
effect once only and always show YES in the download file.
A sample CONFIG.INI is attached below. The italic text following each line describes the
characteristic of the field and the bold italic characters are the options of the field.
Network Camera Initial Configuration File
[SYSTEM]
<reset system>
YES
<host name>
Network Camera
<serial number>
0002D1040011
<software version>
IP21x1-VVTK-0202b
<current date>
2004/06/08
<current time>
12:34:56
<time zone>
0
<user name>
(0)root
(1)
(2)
(3)
(4)
(5)
(6)
or NO
string of maximum 40 characters
read-only
read-only
read-only
read-only
from 12 to -12
read-only
string of maximum 16 characters
the followings are as same as the above
- 59 -