Panasonic DMP-BD85 Operating Instructions Manual page 13

When you experience
problems with settings
Access Point Connection Setting
Access Point Connection Setting
Failed to connect to the access point.
A conflict with other devices occurred.
Do you wish to setup Access Point
Connection Setting again ?
Yes
OK
Display
A conflict with another ≥ Please wait a few moments, and
device occurred.
A time out error ≥ Setting of the Wireless router
occurred.
≥ The signal may be weak. Using
An authentication error
or a time out error
occurred. ≥ The SSID and the encryption
≥ Please wait a few moments, and
≥ Connection of Wireless LAN
A device error
occurred.
Network Easy Setting (Connection Test)
Network Easy Setting (Connection Test)
Complete.
1. LAN cable connection : Fail
2. IP address setting : Fail
3. Connection to gateway : Fail
LAN cable is not connected.
Please check the connection.
Select "Yes" and press [OK] to check network
connection again.
Select "No" and press [OK] to finish Network
Easy Setting.
Yes
OK
Display
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
No
Check the following
then try again.
(Access point) for MAC Address
etc.
the supplied USB extension
cable, adjust the position of the
Wireless LAN Adaptor. Do not
use any other USB extension
cables except the supplied one.
key of the Wireless router
(Access point).
then try again.
Adaptor
If there is no improvement in
symptom, consult your dealer.
No
Check the
following
≥ Connection of
:Fail
the LAN
cables
:Fail
10)
(
:Fail
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
1. LAN cable connection or
Connection to access point
2. IP address setting
3. Connection to gateway
Network Easy Setting (Internet Connection Test)
Network Easy Setting (Internet Connection Test)
Complete.
- Connection to the Internet : Fail(B019)
Failed the connection test.
Cannot find the server.(B019)
Please refer to the operating instructions for the cause
of the error and the solution for it.
Press [OK].
OK
Display
≥ "Primary DNS" and "Secondary
Cannot find the server.
(B019)
≥ The server may be busy or the
Failed to connect to
the server.
(B020)
≥ Settings of "Proxy Server
≥ Refer to the operating instructions of the hub or router.
≥ You can perform this setup anytime by selecting "Network Easy Setting" in
the Setup menu. ( 31)
≥ You can redo these settings individually using "Network Settings". (
≥ Do not connect to a wireless network for which you do not have usage
rights. Wireless networks for which you do not have usage rights (SSID)
may appear during the automatic search for a wireless network
environment. However, if you connect, there is a risk that it will be
regarded as illegal access.
≥ After performing network settings on this unit, the settings (encryption
level, etc.) of the Wireless router (Access point) might change.
When you have trouble getting online on your PC, perform the network
settings on your PC in accordance with the settings of Wireless router
(Access point).
≥ Connection
:Pass
and settings
of the hub
:Fail
and router
≥ Settings of
:Fail
"IP Address /
DNS
:Pass
Settings"
( 31)
:Home
network
available
:Fail
:Pass
:Pass
:Fail
Check the following
DNS" settings of "IP Address /
DNS Settings" ( 31)
service may have been
suspended. Please wait a few
moments, and then try again.
Settings" ( 31) and the router
VQT2H83
31)
13