Diamond Blades - Husqvarna K3000 Cut-n-Break Operator's Manual

Checking the blade guards
WARNING! Always check that the guard is
!
correctly fitted before starting the machine.
Check that the cutting blade is fitted
correctly and does not show signs of
damage. A damaged cutting blade can cause
personal injury. See instructions under the
heading Assembly.
• Check that the guard is complete and without any cracks
or deformations.
• Never use a defective guard or a guard that has not been
fitted correctly.
Ground fault circuit interrupter
Ground fault circuit interrupters are for protection in case an
electrical fault should occur.
The LED indicates that the ground fault circuit interrupter is on
and that the machine can be switched on. If the LED is not
on, push the RESET button (green).
Check the ground fault circuit interrupter
• Connect the machine to the socket. Push the RESET
button (green) and the red LED lights up.
• Start the machine.
• Push the TEST button (blue).
SAFETY INSTRUCTIONS
• The ground fault circuit interrupter should trip and the
machine switch off instantly. If not, contact your dealer.
• Reset with the RESET button (green).

Diamond blades

WARNING! Blades can break and cause
!
serious injuries to the user.
Never use blades other than original blades
designed for the machine.
Never use blades on a material other than
the one they are intended for.
WARNING! Cutting plastics with diamond
!
blades can cause kickback when the
material melts, due to the heat produced
when cutting, and sticks to the blades. Avoid
cutting plastics.
General
• Only use special diamond blades with integrated belt
pulley halves on this machine.
• Diamond blades consist of a steel body provided with
segments that contain industrial diamonds.
• Always use a sharp diamond blade.
• Ensure the blades are not cracked or damaged in any
other way.
• Replace blades if necessary.
– 9
English