Table of Contents
Advertisement
3. Carefully withdraw the light
assembly from the recesses and
remove.
4. Turn bulb holder anticlockwise
and remove. Replace bulb by
withdrawing:
Reverse light 1
Turn signal light 2
Tail light, brake light and rear fog
light are designed as LEDs. In
case of failure, have LEDs
replaced by a workshop.
5. Insert bulb holder into the tail light
assembly and turn clockwise. Fit
light assembly with the retaining
pins into the recesses of the
tailgate and tighten the securing
nuts from the inside of the tailgate.
Close cover.
Additional tail lights in the tailgate
frame
1. Open tailgate.
2. Release cover in side trim panel
and remove.
Vehicle care
3. Press out lamp housing from the
inside of the side trim panel.
4. Rotate plastic nut anticlockwise
and remove from the bulb holder.
233
Advertisement
Chapters
Table of Contents
