Natural-Fit Handrims
Assembly and Installation Instructions
NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Invacare for further instruction.
NOTE: This instruction sheet applies to the following Natural‐Fit Handrim Kits:
1145545
1145550
1163646
1163651
To ensure the safe and proper installation of the handrims, these instructions MUST be
followed:
DO NOT install this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact Invacare, before attempting to install this equipment -
otherwise, injury or damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
This procedure MUST be performed by a qualified technician.
After any adjustments, repair or service and before use, make sure that all attaching
component parts are secure.
Proper installation is critical to the performance of the handrim.
Removing/Installing Handrims with Rivnuts
NOTE: For this procedure, refer to FIGURE 1 on page 2.
Tool Needed:
• Screwdriver
1. Remove the wheel from the wheelchair. Refer to the wheelchair owner's manual.
For more information regarding Invacare products, parts, and services,
Part No. 1144492
1154546
1145547
1145550
1145552
1163647
1163648
1163652
1163653
Safety Summary
WARNING
ACCESSORIES WARNING
INSTALLATION WARNING
please visit www.invacare.com
1145548
1145553
1163649
1
1145549
1145554
1163650
®
Natural-Fit Handrims