Common Pool Problems - Intex HT30220 Owner's Manual

Electric pool heater 230 v~, 50 hz 3000 w, ip25 max. water temperature 35' c
Hide thumbs Also See for HT30220:
Table of Contents

Advertisement

PROBLEM
DESCRIPTION
• Greenish water.
ALGAE
• Green or black
spots on pool liner.
• Pool liner is
slippery and/or
has a bad odor.
• Water turns blue,
COLORED
brown, or black
WATER
when first treated
with chlorine.
• Water is cloudy or
SUSPENDED
milky.
MATTER IN
WATER
• Level is lower than
CHRONIC LOW
on previous day.
WATER LEVEL
• Dirt or sand on
SEDIMENT
pool floor.
ON POOL
BOTTOM
• Leaves, insects
SURFACE
etc.
DEBRIS
If you continue to experience difficulty, please contact our
Consumer Service Department for assistance. See back cover for
contact information.
SAVE THESE INSTRUCTIONS
(114) ELECTRIC POOL HEATER ENGLISH 7.5" X 10.5" PANTONE 295U

COMMON POOL PROBLEMS

CAUSE
• Chlorine and pH
levels need
adjustment.
• Copper, iron or
maganese in water
being oxidized by
the added chlorine.
Common.
• "Hard water" caused
by pH level being too
high.
• Chlorine content is
low.
• Foreign matter in
water.
• Rip or hole in pool
liner or hoses. Tighten
caps.
• Heavy use, getting in
and out of pool.
• Pool too close to
trees.
IMPORTANT
REMEDY
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended
level.
• Vacuum pool bottom.
• Maintain proper chlorine
level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Clean cartridge frequently.
• Correct pH. Check with pool
dealer for water treatment.
• Check for proper chlorine
level.
• Clean or replace your filter.
• Repair with patch kit.
• Finger tighten all caps.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
Page 12
12/18/2006
114

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents