Software Settings - Husqvarna PP 440 HF Operator's Manual

ASSEMBLING AND ADJUSTMENTS
Charging time for a flat battery is approx. 2-3 hours. The diode
is orange when charging starts and becomes green when the
battery is fully charged. When the battery is fully charged the
charger supplies the battery with maintenance current until
the battery is removed from the charger.
Keep the battery charger dry and protected against
temperature fluctuations.
To charge with the CAN cable
The battery is charged when the CAN cable from the power
unit is connected to the remote control. This is indicated by a
red battery symbol in the remote control.
>MENU
DRIVE CHOICES
SETTINGS
SERVICE
If the battery is removed while the remote control is
connected to the CAN cable, the battery symbol in the remote
control will be stricken through to indicate that there is not
battery available.

Software settings

Pair the remote control with the power unit
The first time the remote control is connected, the remote
control and the power unit must be paired. This is a safety
measure to guarantee that the power unit can only be
controlled by one remote control. The remote control cannot
be used until this step has been performed.
• Connect the remote control using the supplied CAN-
cable. Tighten the cable connector screws by hand.
8 –
English
20 DEC 20:55
• Allow the remote control to fully charge and await the
home screen.
• Press the "OK" button to access the menu.
ON/OFF
• Go to "SETTINGS". Browse with the arrow keys and
confirm with "OK".
>MENU
DRIVE CHOICES
SETTINGS
SERVICE
• Go to "PAIR RADIO". Browse with the arrow keys and
confirm with "OK".
>>SETTINGS
SET ROT. DIR.
[STANDARD]
SET FUSE
[32A]
SET WATER VALVE
[AUTO]
PAIR RADIO
A message is displayed on the screen to indicate if the pairing
was successful or not. Try again if the pairing fails.
Other software settings
A number of further settings should be made before the
power unit is commissioned. See instructions in the "Menu
system" section for additional information.
• Set time and date. (SETTINGS>TIME & DATE)
• Select the required display language. (SETTINGS>SET
LANGUAGE)
• Select the required units. (SETTINGS>SET UNITS)
OK
0
20 DEC 20:55
20 DEC 20:55