Advertisement
Installing the battery
1. *Remove the battery cover.
2. Insert the battery by aligning the gold-colored contacts
with the contacts in the battery slot.
3. Push down the upper section of the battery until it clicks
into place.
4. Replace the battery cover and close it gently.
How to insert the SIM/SD card
You want a mobile phone that is sophisticated yet easy to use
and here it is in your hands! Naturally you are eager to start
using it, but first you need to insert the SIM card.
Insert the SIM and memory card as follows:
Make sure that the phone is switched off and the charger is
disconnected from the phone.
Turn the phone over and remove the battery cover.
Remove the battery if it is already installed.
Hold your SIM card with the cut corner oriented as shown and
then slide it into the card holder with the gold-colored
contacts facing downward.
Insert the memory card with the metal contacts facing down
Push down the battery
until it clicks to the right position.
Replace the battery first, then replace the battery cover.
11
Removing the battery
1. Make sure that your mobile phone is switched off.
2. *Remove the battery cover.
3. Pull the battery up and remove it from the mobile phone.
Pull up the battery
* Note: The correct way to remove the battery cover varies
with the model of the mobile phone. Please refer to the
following diagrams.
12
remove the battery cover
Insert the memory card
* Note: SD card not hot-swappable. You can use memory card
to expand the storage of the phone. You can store or copy files
such as music and so on.
Do not take out the card or switch off the phone while
transmitting or storing data, which may cause data loss or
damage to the phone or the card.
13
15
What is a SIM card?
Every mobile phone has a SIM card (Subscriber Identity Module).
This is a micro-chip that holds your personal information such
as names and phone numbers. Your phone won't work without
it. If you already have contacts on your SIM card, they can
be transferred in most cases.
How to charge the battery
Your phone is powered by a rechargeable battery. For maximum
battery performance, it is recommended that you first use up the
battery power and then charge it completely. A new battery's
Insert the SIM card
full performance is achieved only after three complete charge
and discharge cycles.
Connect your travel adapter to the side of your mobile phone
as shown in the diagram.
Note: The side with arrow should be upright while connecting.
Connect the other end of the travel adapter to the mains
socket.
If you charge the battery when the phone is switched off, the
battery indicator appears with the bars moving from right to
left. If you charge the battery when the phone is switched on,
the battery indicator appears with a progress bar.
When the battery is fully charged, disconnect the charger.
Pull out the SIM card
14
16
Move Cursor to Left or Right: Press the Left/Right navigation
keys to move the cursor to left or right.
*Note: Abc mode is only available for certain models.
How to add people to your Contacts
There are some numbers that you may want to call again and
again, so it makes sense to add these numbers to your contact
list. You can then access these numbers quickly and easily.
1. Go to Menu>Contacts>Options>New
2. Edit the information and save it.
You can also save a number right after you've made or
received a phone call or a text message from someone who is
not yet in your Phonebook list.
To delete someone from your Phonebook list, first select the
name, then select Options>Delete.
How to make and receive calls
Insert
The most basic way to make a call is to input the number in the
Powering on/off your phone
standby mode and press the Send key. You can also make a
call from the Phonebook list.
Make sure that your SIM card is in your mobile phone and that
To call someone: Go to Menu>Contacts. Use the Up/Down
the battery is charged.
keys to find the name of the person you want to call. You can
Please hold the End/Power key to power on/off the phone.
also type in the first letter of the name of the person you want
The phone will automatically search for the network.
to call to find the right name, and press the Send key.
To receive a call, press the Send key.
17
Writing text
To end a call, press the End/Power key.
To reject a call, press the End/Power key.
Change input mode: Press the # key to change the input
Make sure that you are in an area with sufficient coverage to
mode (input modes: En,en,EN,*Abc, abc, ABC and 123).
make calls. The strength of the network signal is indicated on
Input Letters: In *Abc/abc/ABC mode, press the
the Status Bar of the screen.
corresponding letter key till the letter appears.
Input Words: In En/en/EN mode, input any letter with a single
How to send and receive messages
key press. Press each key only once for every letter. The word
changes after each key stroke. Predictive text input is based
You can use your mobile phone to send and receive messages.
1. Go to Menu>Message>Write message.
on a built-in dictionary. When you have finished writing the
word and it is correct, confirm it by pressing the 0 key or the
2. Write your message, and, edit the recipient. For more
Centre key. If the word is incorrect, press the Up/Down keys
information on input method, see section 'Writing text'.
to view other matching words found in the dictionary.
When you write an SMS, press Options>Send, and then
Pressing the Navigation keys moves the cursor.
send it.
Input Digits: In 123 mode, press digit key once to input a
3. When you finish writing an SMS, select Options to send or
digit. In En/en/EN mode, press the digit key, and select the
save the message.
number by pressing the Navigation keys. In *Abc/abc/ABC
Upon receiving a message, the mobile phone will alert you with
mode, constantly press the digit key until the number
a ringtone, prompt, or a new message icon.
appears.
1.
Press Read to enter the Inbox directly and then press the
Input Symbol: Press the * key to enter a symbol. In
Center key to reply the message.
*Abc/abc/ABC mode, constantly press the 1 key till the
2.
Use the Up/Down keys to view the message.
required symbol (common symbols) appears.
3.
While the message is open, use Options to reply, delete, or
Input Space: Press the 0 key to input space. It does not work
forward the message. You can also call back the sender.
in 123 mode.
Delete Character: Press the Right soft key to clear a character.
Hold the Right soft key to delete all characters and clear the
display.
18
How to set your phone
You can adjust various settings of your phone.Go to
Menu>Settings.
Phone settings: Select language, set auto power on/off, Date
and time,etc.
Network selection: Set to automatically or manually select
network.
Security settings: Set security features to protect you from
unauthorized use of your phone and SIM card.
Phone settings>Restore factory settings: Enter the phone
password to restore to the factory settings. Some personal
information might be lost if you use this function, so be
careful.
Note: You may be required to input the phone password in
some of the security settings interfaces. The default
password is 1234. You also can change the password in
Settings.
How to set your alarm
Set alarm: Go to Menu>Alarm, You can view, and edit the
alarm clocks settings. You can also enable or disable the
alarms, or set the corresponding features of the alarm
according to instructions: Alarm Message (if required),
Time,Ringtone,and Repeat mode.
19
21
*FM Radio
Go to Menu>FM radio.
With the radio, you can search for radio channels, listen to
them, and save them on your device. Note that the quality of
the radio broadcast depends on the coverage of the radio
station in that particular area. In the FM radio interface, you
can press the Up/Down keys to adjust volume, press the
Left/Right keys to tune the frequency, and press the Centre key
to pause. Select Options to enter the submenu.
Note: please take your handset as the standard.
20
22
Advertisement
