Connecting Wires To Terminals - Kenwood KDC-W4034A Instruction Manual

Connecting Wires to Terminals

REMO. CONT
B
Fuse (10A)
Wiring harness
(Accessory1)
8 6 4 2
7 5 3 1
8 6 4 2
7 5 3 1
KDC-W4534
A To Steering remote
B To Kenwood disc changer/
External optional accessory
A
C Rear left output (White)/
Rear right output (Red)
C
FM/AM antenna input
TEL mute wire (Brown)
If no connections are made, do
not let the wire come out from
the tab.
Power control/ Motor
antenna control wire
(Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page.
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
KDC-W4034A/W4034AY/
W4034G/W4034GY/
W410A/W410AY/W410G/
W410GY/3034A/3034G
To Steering remote
Rear left output (White)/
Rear right output (Red)
To connect these leads, refer to the relevant
instruction manuals.
Antenna Cord (ISO)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
AUX Input adaptor
(Accessory4)
Connect to the terminal that
is grounded when either the
telephone rings or during
MUTE
conversation.
To connect the Kenwood
navigation system, consult
your navigation manual.
Connect either to the power
control terminal when using the
optional power amplifier, or to
P.CONT
the antenna control terminal in
ANT.CONT
the vehicle.
KDC-W434A/
W434G/W434GY/
W40G
—
To external audio unit
(Portable Audio, etc.)
English
—
—
—
27
|