Page 1
OWNERS INSTALLATION AND USER GUIDE QUARTZ INFRARED FIREPLACE STOVE HEATER Model: L-SIFST-S Safety Notice Please read this entire Installation and Operating Manual BEFORE installing and using your new Infrared Fireplace Heater. Failure to fully understand and follow instructions may result in property damage, bodily injury, or even death.
Page 2
Thank you for choosing a LIFESMART Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
10. Never place heater where it may fall into a bathtub or other water receptacles. 11. Do not run cord under carpet. Do not cover cord with throw rugs, runners, or similar coverings. Arrange cord away from traffic area and where it will not be tripped over. 12.
Page 5
Manufacturer, although it is not recommended, due to the amount of work (unless you are a certified heater technician or authorized directly by LIFESMART PRODUCTS Technical Support). All parts may be purchased through LIFESMART PRODUCTS if your product is out of warranty.
The log prop may get warm, but will not melt, burn, or get excessively hot if left on all night/day. For your/your family’s safety Lifesmart advises all customers not to place any items or body parts into the heater’s flame effect chamber and to keep kids and pets away from opening the flame effect door.
FRONT VIEW (With Open Control Panel Access Door ) Flame
E ffect Control
P anel
Freestanding
L egs/Feet REAR VIEW Rear
A ir
I nlet
V ents Rear
C over Power
C ord
I nlet
...
Page 9
“set it and forget it” heater until it is time to turn off and unplug. o Lifesmart’s future models will accommodate a remote control option. Ø The Control Panel is located inside the access door directly beneath the simulated flame.
Page 10
Knowing Your Control Panel: 1. Locate the control panel access door directly beneath the simulated flame. • Pull the control panel access door open, by pulling the knob outward. 2. The control panel consists of two knobs and 4 switches. Here is their location and their function: A.
Page 11
The Next section shows you how to use your heater in all 7 recommended combinations. Please reference “Heater Diagram” or “Control Panel Diagram” for key component locations, if needed. Instructions For Use (With Master Switch On / In Stand By Mode) ü...
Page 12
ü To
T urn
O n
t he
F lame
E ffect
i n
t he
L ow
H eat
M ode:
1. Turn
t he
F an
S witch
t o
t he
O N
p osition
( switch
“ B”).
2.
Maintenance Ø Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater. Ø Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner. Ø Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution of mild detergent and water.
Page 14
Replacing the Flame Effect Lamps/Bulbs Precautions Before Replacing Lamps/Bulbs Ø Always make sure you have consulted with Lifesmart Technical Support for proper troubleshooting, authorization, procedures for any self-maintenance or service of the heater. Ø Warning-Always disconnect the heater from the power outlet before replacing bulbs.
Page 15
4. Slide the rear cover down and out of the heater railings. Rear
Cover REAR
O F
H EATER 5. Place the cover safely out of the way so that it does not get tripped on or damaged.
Page 16
8. Replace with T4 shape/ G9 base 25 watt bulbs only (qty 2). If unsure if you have the correct bulbs or if you cannot find elsewhere, you may always obtain or purchase from Lifesmart Technical Support. Do not exceed 25W per bulb as excessive heat may occur.
Page 17
Troubleshooting Basic Issues Problem Solution Plug in but no power Master switch on panel should be turned ON Verify you have Power from your outlet by testing Master Switch ON but no power another small appliance on it Low Heat Mode Does Not work Control Panel Issue-Replace the control panel but High does High Heat Mode Does Not work...
Page 18
LIFESMART warranty department. The purchaser may also opt to ship the product to LIFESMART to have it repaired. The purchaser will be responsible to prepay any shipping charges (both ways), export taxes, custom duties and taxes, or any other charges associated with the transportation of the unit.
Page 19
Protectors/GFCI Disclaimers LIFESMART shall not be liable for any loss due to use (or misuse) of the heater or other LIFESMART or other incidental or consequential costs, expense or damages without irrefutable foundations. Under no circumstances shall LIFESMART or any of its representatives be held liable for injury to any person or damage to any property, however arising.
Be Patient, Clear, and Concise. Describe the issue and symptoms you have for, and about the product. A certified LIFESMART Technical Support agent will give you an evaluation of your issue and your resolution options. If the answer is not available at that time, you will be referred to the appropriate channels, or given a call/e- mail back within 72 hours with an answer or resolution.