Table of Contents
Advertisement
While searching, <PS> appears
PS
and then the station names will
(Program
be displayed. <NO PS> appears
Service)
if no signal is sent.
While searching, <RT> appears and
then text messages the station sends
RT(RadioText)
will be displayed. <NO RT> appears
if no signal is sent.
Decodes the real time clock from the
FM frequency.
CT (Clock Time)
Some stations may not transmit PTY,
RT or CT information therefore this
may not be displayed in all cases.
Station frequency (non-RDS
Frequency
service)
About characters shown in the display
When the display shows PS,or RT signals,the
following characters are used.
The display window cannot differentiate upper
●
case and lower case letters and always uses upper
case letters.
The display window cannot show accented letters,
●
<A,> for instance, may stands for accented <A's> like
<À, Â, Ä, Á, Å and Ã.>
●
PTY(Program Type) indication and
PTY-SEARCH function(Optional)
One of the advantages of the RDS service is that
you can locate a particular kind of program from the
preset channels by specifying the PTY codes.
To search for a program using the PTY codes
Before you start!
•
The PTY Search is only applicable to preset stations.
•
To stop searching any time during the process, press
the STOP button while searching.
•
There is a time limit in doing the following steps.
If the setting is cancelled before you finish, start from
step 1 again.
•
When pressing the buttons on the primary remote
control, make sure that you have selected the FM
station using the primary remote control.
1.
Press the RDS PTY button while listening to an FM
station.
2.
Press the TUNING/ALBUM , or . buttons until
the PTY code you want appears on the display.
•
The display gives you the PTY codes described
to the right.
3.
Press the RDS PTY button again, while the PTY
code selected in the previous step is still on the
display.
•
The centre unit searches 30 preset FM stations,
stops when it finds the one you have selected,
and tunes in that station.
Setting the Clock
For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1.
Switch the system on by pressing the POWER
button.
2.
Press TIMER/CLOCK button and then press the
ENTER button,"CLOCK" is displayed.
3.
Press ENTER,the hour flashes.
Increase the hours:
●
Decrease the hours:
●
4.
When the correct hour is displayed,
press ENTER, the minutes flashes.
Increase the minutes:
●
Decrease the minutes:
●
5.
When the correct minute is displayed, press
ENTER," TIME" appears in the display.
The current time is set now.
●
You can display the time, even when you
●
are using another function, by pressing the
TIMER/CLOCK button once.
You can also use [ or ] on the top
●
panel instead of TUNING/ALBUM ,or .
buttons in step 3,4.
.
,
.
.
,
,
.
.
11
English
Hide quick links:
Advertisement
Table of Contents
