AEG LAVAMAT 61470 WDBI User Manual page 28

28 www.aeg.com
Problem
Unsatisfactory washing
results:
The door will not
open:
The machine vibrates
or is noisy:
Spinning starts late or
the machine does not
spin:
Possible cause/Solution
Too little detergent or unsuitable detergent has
been used.
• Increase the detergent quantity or use another
one.
Stubborn stains have not been treated prior to wash-
ing.
• Use commercial products to treat the stubborn
stains.
The correct temperature was not selected.
• Check if you have selected the correct tempera-
ture.
Excessive laundry load.
• Reduce the laundry load.
The programme is still running. The programme is still running. The programme is still running.
• Wait the end of washing cycle. • Wait the end of washing cycle. • Wait the end of washing cycle.
The door lock has not been released. The door lock has not been released. The door lock has not been released.
• Wait until the DOOR light has gone off. • Wait until the DOOR light has gone off. • Wait until the DOOR light has gone off.
There is water in the drum. There is water in the drum. There is water in the drum.
• Select drain or spin programme to empty out the • Select drain or spin programme to empty out the • Select drain or spin programme to empty out the
water.
The transit bolts and packing have not been re- The transit bolts and packing have not been re- The transit bolts and packing have not been re-
moved. moved. moved.
• Check the correct installation of the appliance. • Check the correct installation of the appliance. • Check the correct installation of the appliance.
The support feet have not been adjusted The support feet have not been adjusted The support feet have not been adjusted
• Check the correct levelling of the appliance. • Check the correct levelling of the appliance. • Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum. The laundry is not evenly distributed in the drum. The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
The electronic unbalance detection device has cut in
because the laundry is not evenly distributed in the
drum. The laundry is redistributed by reverse rota-
tion of the drum. This may happen several times be-
fore the unbalance disappears and normal spinning
can resume. If, after some minutes, the laundry is still
not evenly distributed in the drum, the machine will
not spin.
• The laundry load is perhaps to little, add more
items, redistribute the load manually and then se-
lect the spinning programme.