Deck Mechanism Disassembly; Holder Assembly Clamp; Plate Clamp; Magnet Clamp - NAD T 751 Service Manual

DECK MECHANISM DISASSEMBLY

HOLDER CLAMP

PLATE CLAMP

(A)
PLATE CLAMP

MAGNET CLAMP

UPPER CLAMP

BASE TRAY

(L1)
(B)
A
Fig. 4-1
1. Holder Assembly Clamp(Fig. 4-1)
1) Release 3 Screws(S1).
2) Unlock The Connectors (C1), (C2) from the Hook(H1).
1-1. Plate Clamp
1) Hold and fix the Upper Clamp under the Holder
Assembly Clamp, and then turn the Plate Clamp to the
counterclockwise direction(arrow(A)).
1-2. Magnet Clamp
1-3. Upper Clamp
1-4. Holder Clamp
Note
• When reassembling, hold and fix the Upper Clamp as
above No. 1-1(1), and then turn the Plate Clamp to the
clockwise direction.
2. Base Assembly Tray(Fig. 4-1)
1) Turn the portion to the direction of arrow(B) to move
the Base Assembly Tray in front of you.
2) Push down two Locking Tabs(L1) located to both sides
of the Base Main, and then pull the Base Assembly
Tray in fornt of you.
(S1)
(S1)
(S1)
(H1)
HOLDER CLAMP
(C2)
(C1)
BASE MAIN
(L1)

BASE ASSEMBLY TRAY

BASE MAIN

2-1. Tray Disc(Fig.4-2)

1) Release Screw(S2).
Note
• Put the Base Assembly Tray face down(Bottom side).

2-2. Roller Base Tray

1) Unlock the two Locking Tabs(L2).

2-3. PCB Assembly Tray

1) Release two Screws(S3).
2) Unconnect the Connector(C3).
Note
• Put the Base Assembly Tray on original position(Top Side).

2-4. Motor Assembly Tray

1) Release 2 Screws(S4).

2-5. Gear Tray

2-6. Gear Wheel Tray

2-7. Base Tray
4-2
(S2)
TRAY DISC
(S4)
(S4)
MOTOR ASSEMBLY TRAY
GEAR TRAY
GEAR WHEEL TRAY
BASE TRAY
ROLLER BASE TRAY
(L2)
BASE TRAY
(L2 )
PCB ASSEMBLY TRAY
(C3)
(S3)
(S3)
Fig. 4-2