Important Safeguards • Do not operate if the housing is removed or damaged. When using an electrical appliance, • A loose fit between the wall socket and plug basic precautions should always be may cause overheating and damage to the followed to reduce the risk of fire, plug.
Connection to the The BROWN wire is the LIVE wire and must be connected to the terminal which is marked with Mains Supply the Letter ‘L’ or coloured RED. Always ensure that the plug cord grip is fastened Check that the voltage marked on the product correctly.
Installation Instructions Before Using Your Wine Cooler 589 (Door) • Remove all exterior and interior packing. • Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation.
Installing the Handle Attention • Store wine in sealed bottles. FRONT • Do not overload the cabinet. • Do not open the door unless necessary. • Do not cover shelves with aluminum foil or any other shelf material which may prevent air circulation.
Reversing the Door 1. Open the glass door and remove the two screws under the right bottom corner of the glass door Swing of Your Appliance that are used to hold the right lower hinge to the glass door. Be careful to support the glass door with hands to prevent it dropping after removing Should you desire to reverse the opening the screws.
Operating Your Setting the Temperature Control Wine Cooler The wine cooler has two temperature zones. • Upper zone – temperature range 5-12°C The Wine Cooler should be placed in a position where the ambient temperature is between • Lower zone – temperature range 12-18°C 0-35°C.
Care and Maintenance Replacing Your Light Bulb NOTE: Removing Shelves Before removing the light bulb, turn off the appliance and disconnect from the • To remove any of the shelves from the rail power supply. Failure to do so could compartment, remove the plastic stops on result in electrical shock or personal either side of the shelf by unscrewing the...
Moving Your Wine Cooler Cleaning Your Wine Cooler • Remove all items. • Turn off the power, unplug the appliance, and remove all items including shelves and rack. • Securely tape down all loose items (shelves) inside your appliance. • Wash the inside surfaces with a warm water and baking soda solution.
Problems with Your Wine Cooler You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling customer service. Troubleshooting Guide Problem Possible Cause Wine Cooler does not operate.