Table of Contents
Advertisement
Automatically scanning for TV channels using
the antenna
When you scan for channels, your TV searches for
channels available in your viewing area and stores
the channel information in the channel list. When
you press CH+ and CH–, your TV tunes to the next
or previous channel in the channel list and skips any
channels that were not stored in the list.
To automatically scan for TV channels using the
antenna:
1 Make sure that you have selected the TV signal
source. For more information, see "Selecting the
TV signal source" on page 11.
2 Press MENU, then press
(TV mode icon). The channel menu opens.
Antenna/Cable
Auto Channel Search
Add/Skip Channels
Favorites
Channel No.
Channel Label
Select
3 Press OK/ENTER or
Antenna/Cable
Auto Channel Search
Add/Skip Channels
Favorites
Channel No.
Channel Label
Select
12
or
to highlight
Antenna
8.2
WFAA-SD
OK:Enter
Menu:Exit
to access the menu.
Antenna
8.2
WFAA-SD
Adjust
Menu:Return
www.insigniaproducts.com
4 Press
or
to highlight Auto Channel Search,
then press OK/ENTER or . The following
screen opens with Start to Scan highlighted.
Cable System
Start to Scan
Select
Select
Adjust
Adjust
5 Press OK/ENTER or
progress screen appears.
RF CH
Found
Menu/Exit: Exit
Your TV scans for analog and digital channels
and stores the information in the channel list.
When the scan is complete, your TV tunes to the
first channel in the channel list.
Note
You can press MENU or EXIT to exit the scan, but you
must run the scan again to create a complete
channel list.
NS-L7HTV
AUTO
Menu:Return
Menu:Return
to start scanning. A
12
4
Advertisement
Table of Contents
