Log Placement - Monessen Hearth DFX24 Installation And Operating Instructions Manual

LOG PLACEMENT

Before you begin — This unit is supplied with a set of three ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with
soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly
positioned in the appliance. Never add additional logs or embellishments such as
pine cones, vermiculite or rock wool to the heater.
DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner.
This may cause sooting. Only place volcanic rock on the floor of the fireplace.
During initial operation of the new heater, burning logs will give off a paper burning
smell and orange flames will be present. Simply open the windows for a few hours
to vent the odor.
PROPER INSTALLATION SEQUENCE (DFX24)
1. Install the rear log (#3) in log bracket. Visually check to verify the log is securely placed.
2. Install the front log (#1) in bracket. Visually center log.
3. Install the center log (#2) behind the front log on the remaining set of locating pins. Visually check to verify the log is
securely placed on the pins.
24
Failure to position the parts in accordance with these
diagrams or failure to use only parts specifically
approved with this heater may result in property damage
or personal injury.
Locating
Pin
Figure 34 - Proper Sequence of Log Installation (DFX24)
Bracket
Tabs
Brackets
Locating
Pin
33D0237