No
Parts
2
Electrical Parts
(Main PCB)
3
Ass'y Tray Drain.
4
Heat Exchanger
Samsung Electronics
Procedure
1) Do "1", above.
2) Take all the connector of PCB upper side out.
(Inclusion Power cord)
3) Separate the outdoor unit connection wire
from the terminal block.
4) If pulling the Main PCB up. It will be taken
out.
1) Do "1", "2", above.
Separate the drain hose from the extension
drain hose.
2) Pull tray drain out from the back body.
1) Do "1", "2", "3", above.
2) Loosen two fixing earth screws of right side.
3) Separate the connection pipe.
4) Separate the holder pipe at the rear side.
5) Loosen the two fixing screws of right and
left side.
6) Lifting the heat exchanger up a little to push
the up side for separation from the indoor
unit.
Disassembly and Reassembly
Remark
3-2