Troubleshooting - Ryobi RPW130SC Original Instructions Manual

TROUBLESHOOTING

Problem
Machine refuses to start
Fluctuating pressure
Motor busses
Machine stops
Fuse blows
Machine pulsating
Machine often starts
and stops by itself
Machine starts, but no
water comes out
Possible causes
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cable
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Low voltage or low temperature
Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Fuse too small
Air in inlet hose/pump
Inadequate supply of mains water
Nozzle partially blocked
Hose kinked
Pump/spray handle is leaking
Pump/hoses or accessory frozen
No water supply
Nozzle blocked
Solution
Plug in machine.
Try another socket.
Replace fuse. Switch off other machines.
Try without the extension cable.
Check that hoses and connections are air tight.
Clean and replace or refer to local distributor .
Clean and replace or refer to local distributor.
Activate the trigger of the spay handle.
Replace fuse. Switch of other machines.
tag.
Leave the washer for 15 minutes to cool down.
Clean the nozzle.
Change to an installation higher than the amp. Consumption of the
machine. You may try without the extension cable.
Allow machine to run with open trigger until regular working pressure
resumes.
model tag) NB! Avoid using long, thin hoses.
Clean the nozzle.
Straighten out hose.
Contact your nearest.
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
Clean the nozzle.