AEG ÖKO-LAVAMAT 86720 update Instruction Book page 29

Malfunction
Washing machine
vibrates during opera-
tion or is unstable.
Excessive foaming dur-
ing the main wash.
Water runs out from
under the washing
machine.
Fabric softener is not
added, compartment
À for fabric softener
is filled with water.
Washing has not been
spun sufficiently, there
is water left in the
drum.
Error code (2 appears.
Possible Cause
The machine is not level.
There is only very little wash-
ing in the machine (e.g. only
a bath robe).
Water could not be com-
pletely pumped out prior to
spinning because
the drain hose is kinked
or
the drain pump is blocked.
Probably too much detergent
was used.
Threaded fitting on the
water inlet hose is leaking.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked.
Drain hose is kinked.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Drain pump is blocked.
The water drainage system is
blocked.
Operating Instructions
Remedy
Adjust the feet according to
the installation and connec-
tion instruction.
Does not impair function.
Check the drain hose and if
necessary remove any kink or
clean the drain pump and
remove any foreign bodies
from the pump housing.
Dose detergent exactly in
accordance with the manu-
facturer’s instructions.
Tighten the inlet hose con-
nections.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Abort the program, remove
the washing caught in the
door, start a new program.
Clean detergent dispenser
drawer, place suction cap
firmly in position.
Remove kink.
Please contact the AEG Serv-
ice Force Centre, it has a
retro-kit available for pump
heights above 1m.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
Clean the blockage.
29