Jøtul F 100 USA Installation And Operating Instructions Manual
Fireplace
Hide thumbs
Also See for F 100 USA:
- Installation and operating instructions manual (20 pages) ,
- Installation and operating instructions manual (60 pages) ,
- Installation and operating instructions manual (48 pages)
Related Manuals for Jøtul F 100 USA
Summary of Contents for Jøtul F 100 USA
- Page 1 Jøtul F 100 USA Installation and Operating Instructions for use in USA and Canada Exploded view Keep these instructions for future reference.
-
Page 2: Standards / Codes
7,700 to 27,000 BTU’s per hour. Accepted For Use City of New York The Jøtul F 100 USA woodstove is only listed to burn Department of Buildings wood. Do not burn any other fuels. MEA 368-04-E Jøtul North America, Inc. -
Page 3: Table Of Contents
USA/CANADA Table of Contents 20 3/4” Standards and Safety Notices 527 mm Standards / Codes ...............2 Safety Notices ................4 1.0 Installation Flue Collar Installation ...............4 Chimney Connector ..............5 22 1/2” 570 mm 2.0 Chimney Requirements Masonry Chimneys ..............6 Prefabricated Chimneys.............6 Chimney Height ................6 Wall Pass-Throughs ..............7 3.0 Connecting to the Chimney... -
Page 4: Safety Notices
USA/CANADA 1.0 Installation Safety Notices • Burn solid wood fuel only If this solid fuel room heater is not properly installed, a house fire may result. For your safety, follow the installation directions. Contact the local building or fire • Do not use chemicals or fluids to start the fire. officials about restrictions and installation inspection Do not burn garbage or flammable fluids. -
Page 5: Chimney Connector
USA/CANADA • For the best performance, the chimney connector should be as short and direct as possible, including no more than two 90° elbows. • The maximum vertical run of single wall stovepipe should not exceed 10 ft. (305 cm). Cut at •... -
Page 6: Chimney Requirements
2’ 61 cm 3’ 91.5 cm Masonry Chimneys When installing the Jøtul F 100 USA into a masonry chimney you must conform to all of the following guidelines: 10’ • The masonry chimney must have a fireclay liner or 305 cm equivalent, with a minimum thickness of 5/8”... -
Page 7: Wall Pass-Throughs
USA/CANADA Chimneys shorter than 14 feet (4.27 m) may not provide The opening must be filled with at least 12” (30.5 cm) adequate draft. Inadequate draft can result in smoke of brick around a fireclay liner. The liner must be ASTM spillage when loading the stove, or when the door is C35 or equivalent, having a minimum wall thickness open. -
Page 8: Connecting To The Chimney
Do not connect this stove to a chimney flue servicing another appliance of any kind. Hearthmount into a Masonry Fireplace The Jøtul F 100 USA may be installed into a masonry fireplace with a minimum opening height of 22 1/2” (572 mm). -
Page 9: Prefabricated Chimneys
B: 46 cm (Can) Floor Protection Floor Protector The Jøtul F 100 USA requires one of the following forms of hearth protection: 1. Any UL, ULC or WH listed hearth board. (No bottom Figure 8. Prefabricated Listed Type HT Chimney. -
Page 10: Alcove Installation
When using double wall connector, Flue Collar Heat The Jøtul F 100 USA can be installed in an Alcove as Shield Kit 154996 must be installed on the stove. diagrammed in figures 10 and 11. - Page 11 USA/CANADA Clearances to Fireplace Mantels and Surround Trim See the Clearance Chart on page 12 for approved clearances to combustible materials that may be part of fireplace construction. See also fig. 12 on page 12...
-
Page 12: Clearance Chart
USA/CANADA Jøtul F 100 USA Clearance Chart All clearances established with included stove rear heat shield installed. Stove Unprotected Surface Protected Surface Clearances Installation per NFPA211 or CAN/CSA -B365-M93 Side Rear Corner* Side Rear Corner* Single-wall Connector 15” 11” 10”... -
Page 13: Clearance Diagrams
USA/CANADA Protected Surface Unprotected Surface Parallel To The Wall Parallel To The Wall PER NFPA 211 or CAN/CSA-B365 Important: Connector heatshields and double wall pipe must be a listed product. Always follow the manufacturer’s instructions. Unprotected Surface Protected Surface Corner Installation Corner Installation PER NFPA 211 or CAN/CSA-B365... -
Page 14: Operation
Break-In Procedure The Jøtul F 100 USA is constructed of cast iron and high temperature furnace cement. This type of construction requires the stove to be “broken-in” gradually so that heat expansion does not occur too quickly and cause damage. -
Page 15: Starting / Maintaining The Fire
USA/CANADA Breakin Odors: It is normal for a new painted stove to Adding Fuel emit odor and smoke during the first few fires. This When reloading the stove while it is still hot and a is caused by curing of the high temperature paint bed of hot embers still exist, follow this reloading and will diminish with each fire. -
Page 16: Maintenance
USA/CANADA 6.0 Maintenance Glass Removal or Replacement The glass may be removed with the door in place. 1. Hold the glass in place while you remove the glass Ash Removal clips from the inside of the door. Lift the glass panel off of the two bottom tabs in the door. -
Page 17: General Maintenance
Close and latch the door and Figure 15. Attach flue collar heat shield. then reopen. Wipe away any excess cement that may have squeezed out from around the gasket. Gasket List for the Jøtul F 100 USA Description Part # Size... -
Page 18: Jøtul N. A. Woodburning Product
USA/CANADA 9.0 Jøtul N. A. wood- Exclusions and limitations burning product limited Notice: This warranty is void if installation or service is performed by someone other than an authorized installer or warranty service agency, or if installation is not in conformance with the installation and operating instructions contained in this owner’s manual or local and/or national fire and building Effective February 1, 2010... - Page 19 USA/CANADA specific legal rights, and you may have other rights, which vary from state to state. JØTUL reserves the right to discontinue, modify or change the materials used to produce the Jøtul or Scan Stove or Fireplace. JØTUL shall have the right to replace any defective component with substitute components determined by JØTUL to be of substantially equal quality and price.
-
Page 20: Illustrated Parts List
USA/CANADA Illustrated Parts Breakdown. Only use replacement parts provided through your authorized Jøtul dealer. - Page 21 Pos. no. Description Dim./Spec. Side plate , left Cast iron Gasket (for rear plate) LD 250-2 Ø6,4x750mm Cover for air manifold Cast iron Heat shield rear Smoke outlet cover Cast iron Rear plate new Cast iron Gasket (for top) LD 375-2 Ø9,5x1620mm Baffle Cast iron Smoke outlet, non dripless Ø125...
- Page 24 Jøtul AS pursues a policy of constant product development. Products may therefore differ in specification, colour and type of accessories from those illustrated and described in this manual. Quality Jøtul AS utilizes quality controls conforming to NS-EN ISO 9001 for product development, manufacturing, and distribution of stoves and fireplaces.