Connect To An Apple Macintosh System - LG 500LC User Manual

Connect to an APPLE Macintosh System

Figure shows the connection to an Apple Macintosh, using a separately
purchased adapter. For more information on adapter requirements, contact your
LG authorized dealer, reseller, or service provider.
Power OFF both the monitor and the PC.
Locate the appropriate MAC to VGA adapter block at your local computer store.
This adapter changes the high density 3 row 15 pin VGA connector to the
correct 15 pin 2 row connection to mate with your MAC. Attach the other end of
the signal cable to the side of the adapter block with 3 rows.
Connect the attached adapter block/signal cable to the video output on your
MAC.
Connect the plug from the AC-DC adapter into the connector on the display unit.
Connect one end of the AC power cord into the AC-DC adapter.
other end into a properly grounded three-prong AC outlet.
Power ON the PC, then the monitor.
If you see the Check Signal Cable message, check the signal cable and
connectors.
After using the system, power OFF the monitor, then the PC.
Note : If you see the "Outside Range Limits" message, check to make sure your system is set
to one of the factory preset modes.(see page A14)
Power Cord
Adapter 15P
Signal Cable
AC-DC adapter
A6
Plug the
D-15P