Table of Contents
Advertisement
A1
A3
B1
C1
C3
Assembly Instructions
A2
B2
C2
C4
Lower Handles
1. Insert the lower handle into the deck as shown in Fig.
A1
2. Push the handle firmly down until it is located
securely into the deck.
3. Insert the screw into the hole using a pozidrive
screwdriver and tighten fully. (A2).
Repeat for other side
Lower Handle Plug
1. Insert the two lower handle plugs into the top of each
of the lower handles (A3).
Upper Handles
When viewing product from the rear the yellow
Warning labels should be facing upwards.
1. Insert the nut into the handle knob (B1)
2. Allign the holes in the upper and lower handles and
secure with the bolt, washer and handle knob (B2).
3. Fit the cables to the handles with the cable ties
provided, making sure the cables are not trapped
between the upper and lower handles.
Cord Guide
1. Attach the cord guide, nut and washers as illustrated
in Fig. C1 using a 10mm spanner.
2. Using a spanner, attach the locknut to the cord guide
until it is secure, (C2) ensuring the cord guide is in the
correct position (C3).
3. Disconnect the spark plug lead.
4. Pull the brake lever fully towards the handle (on left
hand side of handle when viewed from the rear).
5. Extend the pull cord fully.
6. Locate the cord in the cord guide positioned on the
handle (C4).
Advertisement
Table of Contents
