Specifications; Accessory; Applications; Prior To Operation - Hitachi EC 10SB (SL) Instruction Manual And Safety Instructions

SPECIFICATIONS

Model
Motor
Power Source
Input
Current
Tank Capacity
Maximum Pressure
at 40 PSI
(2.8 bar)
Free Air
at 90 PSI
Delivery
(6.2 bar)
at 100 PSI
(6.9 bar)
Lubrication

ACCESSORY

WARNING:
Accessory other than these shown
below can lead to malfunction and
resulting injuries.
STANDARD ACCESSORY
EC 10SB(SL)
NO ACCESSORIES
EC 12

APPLICATIONS

Air source of the pneumatic nailer and stapler.
WARNING:
Never use compressor for
applications other than compressor
for pneumatic nailer and stapler.
EC10SB(SL)
116 PSI
(8 bar)
6.3 CFM
(177 ltr/min)
5.1 CFM
(144 ltr/min)
4.6 CFM
(130 ltr/min)
Oil-less
Dipstick - - - - - - - - - - - - - - 1
Single-Phase, Induction Motor
Single-Phase, 240V AC 50Hz
2 HP
(1.5 KW)
9.5 A
4 gal.
(15.1 ltr)

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specified on the
product nameplate.
2. Power switch
Ensure that the knob of the pressure switch is in the
"OFF" position (Fig. 2). If the plug is connected to a
receptacle while the knob is in the "ON" position, the
compressor will start operating immediately and can
cause serious injury.
ON
OFF
Knob of the pressure switch
EC 10SB(SL)
3. Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient thickness
and rated capacity (refer page 6). The extension cord
should be kept as short as practicable.
WARNING:
Damaged cord must be replaced or
repaired.
— 8 —
EC12
125 PSI
(8.6 bar)
5.9 CFM
(168 ltr/min)
4.8 CFM
(136 ltr/min)
4.6 CFM
(130 ltr/min)
Oil
OFF
ON
EC 12
Fig. 2