Introduction - Empire Comfort Systems FDR30LBP-2 Installation Instructions And Owner's Manual

IMPORTANT: Read all instructions carefully before starting
installation. Failure to follow these installation instructions may
result in a possible fire hazard and will void the warranty.
Save this manual for future reference.
Please read this manual before installing and using the
appliance.
Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
2. Installer must have owner fill out and mail warranty card supplied
with unvented room heater/vented decorative appliance.
3. Installer should show owner how to start and operate unvented
room heater/vented decorative appliance.
Always consult your local Building Department regarding regulations,
codes or ordinances which apply to the installation of an unvented
room heater/vented decorative appliance.
This appliance may be installed in an aftermarket* manufactured
(mobile) home, where not prohibited by state or local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases.
Solid-fuels shall not be burned in a fireplace where a vented decorative
appliance is installed.
A vented decorative appliance must be installed only in a solid-
fuel burning fireplace with a working flue and constructed of non-
combustible material.
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not
shown on the rating plate is the responsibility of the person
and company making the change.
Important
All correspondence should refer to complete Model Number, Serial
Number and type of gas.
Attention: During initial use of log you will detect an odor as
the log is cured.
27604-3-0411

INTRODUCTION

Notice: During initial firing of this unit, its paint will bake out, and
smoke will occur. To prevent triggering of smoke alarms, ventilate
the room in which the unit is installed.
This appliance is for installation only in a solid-fuel burning
masonry or UL 127 factory-built fireplace or in a listed
ventless firebox enclosure. It has been design certified for
these installations. Exception: DO NOT install this appliance
in a factory-built fireplace that includes instructions stating
it has not been tested or should not be used with unvented
gas logs.
Any modification to this unvented gas heater or its controls
can be dangerous. Improper installation or use of the heater
can cause serious injury or death from fire, burns, explosion
or carbon monoxide poisoning.
well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the
Btu output of the unit. Contact the gas company for the heating value.
Contact the manufacturer or your gas company before changing
spud/orifice size.
ACCESSORIES for VFDR, VFDT, & VFDM
EK-1
PE-20
ELH-1
ELH-2
ACCESSORIES for VFDR ONLy
FRBC
FRBTC
FREC
FWS
TRW
TMV
NOTICE: Thermostats are for Vent-Free Applications only.
wARNING
wARNING
Description
Embers Kit
Platinum Embers
Fireplace Hood for Vent-Free Logs
Fireplace Hood for Vent-Free Logs
Battery Operated Remote Control
Battery Operated Remote Control with Thermostat
Electric Remote Control
Wall Switch
Remote Wall Thermostat
Wall Thermostat, Millivolt - Reed Switch
Color
Black
Brass
Page 5