Table of Contents
Advertisement
Handle
Alignment
Holes
Frame
Assy.
STeP 1: Attach handle to the frame
of the pressure washer. Note: It
may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
Safety
latch
High
Pressure Hose
STeP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
Pressure
Wand Coupler
Nozzle
Wand
Collar
STeP 7: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
Pump
Water Inlet
garden Hose
STeP 10: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
6
will result.
ASSeMblY INSTRUCTIoNS
Carriage
bolt
STeP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
Spray
gun
Nozzle extension
STeP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
Coupler Collar
STeP 8: Connect the high pres-
sure hose to the pump discharge
nipple. Push coupler collar forward
until secure.
#9.800-085.0 • REV. 12/06
bolts
Nut
STeP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
Spray
gun/Wand
STeP 6: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
Pump
Cold
discharge
Water
Nipple
Source
High
Pressure
Hose
STeP 9: Connect garden hose to
the cold water source.
Hose/gun
Storage
bracket
Nut
Studs
Pressure
Nozzle
Wand
Coupler
garden
Hose
Advertisement
Table of Contents
