Installing The Macintosh Software; Starting The Macintosh Software Installation - Epson Expression 1600 User Manual

Installing the Macintosh Software

Although you can connect the scanner either before or after installing the scanner
software, you'll see a message that your scanner driver needs to be installed if you
connect it before installing. Close the message and continue with the installation
instructions in the next section. For instructions on installing software for a network
scanner, go to Chapter 4, "Network Scanning."
You can connect the scanner using either a SCSI or USB interface. If you have the
Professional FireWire model of the scanner or you've installed the optional IEEE
1394 FireWire scanner interface card, you can also connect the scanner using the
IEEE 1394 FireWire interface. See "Connecting the Scanner to Your Computer" on
page 25 for instructions on connecting the scanner, and "IEEE 1394 FireWire
Scanner Interface Card" on page 106 for instructions on installing the IEEE scanner
FireWire interface card.
If you've used an EPSON scanner on your Macintosh and
have installed an older version of EPSON TWAIN software,
open the Extensions Manager before you begin installation.
Clear the checkboxes next to EPSON Scanner Monitor
Extension or EPSON Scanner Monitor USB Extension and
restart your computer. Then continue with the instructions
below.

Starting the Macintosh Software Installation

Before you begin, make sure you've recalibrated your monitor to factory
specifications. You can use tools such as ColorSync 2.5 or above, the Adobe Gamma
utility included with Adobe Photoshop 5.0 and above, and MonacoEZcolor. (For
instructions on installing MonacoEZcolor, see "Installing MonacoEZcolor" on
page 51.)
If you don't calibrate your monitor, you may get inconsistent
scanning results.
1. Turn on your Macintosh and turn off any virus protection programs you're using.
2. Insert the EPSON Expression 1600 Scanning Tools CD-ROM in your drive.
47